D-1000B(E) Heater

The D-1000B(E) Heater is rugged, lightweight, rust resistant, shock proof and easy to operate and maintain, providing nearly 100,000 BTU/h of dry, clean heat at a rate of 1,150 CFM. The heater includes an electronic control system that monitors for high heat conditions and flameout, as well as a pre-heated fuel filter that allows the heater to continue to operate in even extreme low temperatures. It can also continuously run for more than 12 hours without the need to refuel, ensuring personnel will have a steady, reliable heat source while working in the field.

• Indirect fuel fired air heater – "Heater Air" is separated from exhaust air passage.
• Pre-heated fuel filter allows heater to work continuously in extreme low temperatures.
• Adjustable fresh air make-up inlet window.
• Safety production:
  • Safety shut off switch if flame is not detected – flame detector.
  • High temperature limit switch shuts down heater if ducts become blocked (exceeding 121°C).
  • Safety shut off switch upon detecting 100ppm of CO content.
• High efficiency heating output of 100,000 BTU/h.
• Stainless steel combustion chamber.
• Two piece moulded polyethylene skid and cover.
• Watertight control panel.
• Runs over 12 hours continuously without refueling fuel tank.
• High temperature sensor in heat exchanger – safety shut off.
• Accurate solid-state remote thermostat control.
• Electronically controlled fuel injection.
• Remote CO (Carbon Monoxide) detector.
• 0.3 m x 4.6 m flexible duct sections (supply and return).
• Visual fuel gauge.
• Fabric duct end covers.

• Combustion: Indirect heat exchanger.
• Heat Input Capacity: 110,000 BTU/h.
• Air Flow: 880 cfm.
• Fuel Consumption: 0.72 UK gal/ h / 3.25 l/h.
• Nozzle: 0,55-80°W.
• Pump Pressure: 13.5 bar.
• Fuel Tank Capacity: 9 UK gal / 45 l.
• Power Supply: Variable Voltage; 110/240V, 1 ~ 50Hz.
• Power Consumption: 520w
• Fuse: 10A.
• Flue Diameter: 15 cm.
• Noise Level at 1m: 74 dBA.